cat#     B06MM5022

Here is the Mobile BALUN designed for serious HF mobile operator's. 
All items shown in the photo are included with the BUXCOMM B06MM5022. 
We designed this asymmetrical to asymmetrical B06MM5022 for use with both: 
screw-driver type and end (bottom) fed vertical mobile antennas. 
NOTICE:  If your screw-driver antenna requires phantom voltage (DC) on the coax
feed-line to run the DC motor of your screw-driver antenna, this BALUN will not pass DC,
and should not be used where phantom DC voltage for the DC motor is fed via the coax feeder.

Install this BUXCOMM mobile B06MM5022 where it counts and where every watt is important.
The BUXCOMM B06MM5022 puts the RF power into your mobile antenna to radiate. 
Without an asymmetrical to asymmetrical UNUN at the input of your mobile antenna,
much of the RF power can become reflected (lost) power (VSWR).

This HF mobile BALUN covers 1.8 MHz. through 54 MHz. This BUXCOMM
Master Match Mobile 5022  is rated at 1000 watts SSB.  Our new BUXCOMM MM5022
will match 50 ohms to lower impedances from 1.5 MHz to 55 MHz.  

More than 95% of all HF mobile antennas exhibit a low impedance input, between 16
and 32 ohms.  Our new BUXCOMM model MM5022 HF mobile BALUN will match 50 ohm
coax to mobile antennas having impedance(s) from 14 to 33 ohms.  I designed this
asymmetrical to asymmetrical MM5022 for mobile applications because most mobile
antennas exhibit this very low input impedance.

*Style and color may vary.    Performance per above specs.